Are you still worried about too many steps? Today Xiao Bian to Kai Bo C2S as an example, teach you to simply a simple five-step brushing machine.
(Applicable to any version of the firmware, it can also be applied to the brick machine, problem recovery. Any version of the firmware can be used to brush this machine.)
1 First move the firmware to the root directory of the SD card, insert the SD card (note that the SD card is not a U disk, only SD card can be used here, and other storage devices on the U disk are useless. The SD card slot is on the side of the box) and then C2S Pull the plug out and find a reset button on the back of the C2S, as shown:
Find a toothpick or cotton swab (personal favorite) to withstand the reconstruction bit, plug in, power on for 10 seconds or so will enter re mode 2 enter re mode after the choice of select 6.7 two, Shuangqing. Pictured:
Shuangqing succeeded after the next step.
3 choose the third item to brush, as shown
Click to enter to find the firmware name, remote control OK button to confirm the brush machine.
4 After the success of the brush machine, select the first item and start the system. (It will be very slow when you enter the system for the first time.)
5 After entering the system successfully, do not use it immediately. It is better to restart it once and then delete the firmware. Brush machine completed.
(Applicable to any version of the firmware, it can also be applied to the brick machine, problem recovery. Any version of the firmware can be used to brush this machine.)
1 First move the firmware to the root directory of the SD card, insert the SD card (note that the SD card is not a U disk, only SD card can be used here, and other storage devices on the U disk are useless. The SD card slot is on the side of the box) and then C2S Pull the plug out and find a reset button on the back of the C2S, as shown:
Find a toothpick or cotton swab (personal favorite) to withstand the reconstruction bit, plug in, power on for 10 seconds or so will enter re mode 2 enter re mode after the choice of select 6.7 two, Shuangqing. Pictured:
Shuangqing succeeded after the next step.
3 choose the third item to brush, as shown
Click to enter to find the firmware name, remote control OK button to confirm the brush machine.
4 After the success of the brush machine, select the first item and start the system. (It will be very slow when you enter the system for the first time.)
5 After entering the system successfully, do not use it immediately. It is better to restart it once and then delete the firmware. Brush machine completed.